1 user manual model qd6523zh outdoor intelligent pan-tilt-zoom dome camera with 23x optical zoom and internal heater.
2 3 © 2013 q-see. Reproduction in whole or in part without written permission is prohibited. All rights reserved. This manual and software and hardware described herein, in whole or in part, may not be reproduced, translated, or reduced to any machine-readable form without prior written approval. Tr...
4 5 features before installing to avoid rough handling, dropping, or other abuse in order to prevent damage to the optics or components inside the camera. N camera should be installed in accordance with electrical standards including keeping the camera and cable away from high voltage, using a trans...
6 7 unlike conventional security cameras, ptz cameras require an address and a connection speed to be set in order for them to properly operate. The default settings for this camera are an address of “1” and a baud rate of 9600 and using the pelco-d protocol. However, if your camera came as part of ...
8 9 step 1. Connect the bnc and power leads from the camera to the matching connectors on a video/power siamese cable (note: these may need to be purchased separately if your camera was not included as part of a bundle package). Connecting the camera before you can operate the camera, you must conne...
10 11 when installing your camera, it is important to select a proper site not only for field of view, but for other considerations as well: distance from viewing/recording device. The further the camera is from the dvr or monitor, the higher the chances of signal degradation. Typical 75Ω video cabl...
12 13 q-see model number qs50b (50’) qs100b (100’) qsvrg60 (60’) qsvrg100 (100’) qsvrg200 (200’) qs59500 (500’) qs591000 (1000’) maximum run length 180’ 800’ 800’ quality output standard high high type 75Ω video cable rg-59 rg-59 shielded no yes - ul rated yes - ul rated plenum rated no no no pre-at...
14 15 additional settings using the camera’s on-screen menu the qd6532z offers additional features that can be accessed through the dvr’s ptz menu, but which are actually programmed on the camera itself. Accessing the menu the following instructions are shown using a qt-series dvr. Step 1. Right-cli...
16 17 past 90° (pointing straight down), the camera will quickly rotate 180° and continue to move the lens as directed. When the camera does this “flip”, the arrow will point down indicating that directions are essentially reversed in this position. Zoom display: shows the level of the optical zoom ...
18 19 focus setup: in this menu, you can turn off the autofocus feature of your camera as well as limit the range that it will focus on and its sensitivity. As the camera does not have infrared lights, the ir light focus correction feature is not applicable. Zoom speed: adjustable from 1-8 aperture ...
20 21 troubleshooting problem solution no picture or unstable image check both the power and video connections to the camera. The on-screen image is blurry. 1. Check for fingerprints or dirt on the lens. 2. Check menu settings. 3. Check that auto-focus is enabled the on-screen image is dim. 1. Check...
22 23 specifications specification camera image sensor 1/4” exviewhad ccd ii eective pixels ntsc: 976(h) × 494(v) pal: 976(h) × 582(v) horizontal resolution color: 650tvl; b/w: 700tvl scanning system interlacing electronic shutter speed 1/1s ~1/100,000s min. Illumination color: 0.01 lux/f1.6, b/w: 0...
24 digital peripheral solutions, inc. 8015 e. Crystal drive anaheim, ca 92807.
