Qms 1725e print system energy star addendum ® 1800395-001a.
Trademarks the following are trademarks or registered trademarks of their respective owners. Other product names mentioned in this manual may also be trademarks or registered trademarks of their respective owners. Registered trademarks are registered in the united states patent and trademark office;...
Introduction 1 introduction with the energy star option installed in your printer, you need to be aware of some differences between your printer and models without this option. The following information explains what the energy star program is and how energy star-compliant printers operate. You will...
Removing and re-installing the tray assembly qms 1725e print system addendum 2 remain inactive for that length of time before starting the energy sav- ing condition. Removing and re-installing the tray assembly when adding options requiring installation inside the printer (memory, intellifont simm, ...
Removing and re-installing the tray assembly 3 3 remove the screw on each end of the side panel by turning it counterclockwise and then remove the side panel. 4 remove the five screws on the metal tray assembly cover and then remove the metal cover, revealing the tray assem- bly..
Removing and re-installing the tray assembly qms 1725e print system addendum 4 5 unplug the three connectors on the tray assembly. N the connector on the left is released by opening the ejector switches on each side of the connector and then pulling out the connector. N the connector in the middle i...
Removing and re-installing the tray assembly 5 6 remove the tray assembly screw located to the right of the fan to release the tray assembly. 7 from the front of the printer, pull the tray assembly straight out, lifting the tray to pull it over the safety catches. Take the tray assembly completely o...
Removing and re-installing the tray assembly qms 1725e print system addendum 6 re-installing the tray assembly o caution: the following procedure is written for the system administrator. Do not attempt this procedure if you have no experience working with circuit boards. 1 using both hands, carefull...
