QMS 1725E Supplementary Manual - page 6
Other manuals for 1725E:
Getting Started Manual
of
8
Removing and
Re-Installing
the Tray
Assembly
QMS 1725E Print System Addendum
4
5
Unplug the three connectors on the tray assembly.
n
The connector on the left is released by opening the ejector
switches on each side of the connector and then pulling out
the connector.
n
The connector in the middle is released by pressing in the tab
on each side with one hand and pulling the connector out
with the other hand.
n
The connector on the right is released by pressing down gen-
tly on the top of the connector’s flexible latch while pulling the
connector out.
Note: The connector on the right is found only on printers with the
Energy Star option installed. Non-Energy Star compliant printers
have only two connectors attached to the tray assembly.
Connectors