QMS 2425 Operation Manual - page 139
,PDJH'HIHFWV
7URXEOHVKRRWLQJ3ULQWHU3UREOHPV
,PDJH'HIHFWV
The following list includes several image defects with possible solu-
tions. Try the solutions in the sequence given. If the solutions listed
don’t solve the problem, place a service call to your QMS vendor. See
the next section in this chapter, “Placing a Service Call.”
:KLWHRU/LJKW/LQHV
1
Remove the toner cartridge and gently rock it from side to
side as you would before installing a new cartridge.
This redistributes toner inside the cartridge. Reinstall the car-
tridge.
2
If step 1 does not solve the problem, install a new toner car-
tridge.
/LJKW,PDJH(QWLUH3DJH
1
Make sure you pulled the tab from the toner cartridge.
2
Increase the print density by adjusting the print density
through the Administration/Engine configuration menu.
3
Make sure that the Conserve Toner option is disabled under
the Administration/Engine/Print Quality configuration menu.
4
Remove the toner cartridge and gently rock it from side to
side as you would when installing a new cartridge.
This redistributes toner inside the cartridge. Then, reinstall the
cartridge.
5
If steps 1, 2, 3, and 4 do not solve the problem, install a new
cartridge.
'DUN,PDJH(QWLUH3DJH
1
Decrease print density by adjusting the print density through
the Administration/Engine menu on the configuration panel.