QMS 2425 Operation Manual - page 157
3ULQWHU+RPH
3DJH
&URZQ9LHZ3ULQWHU:HE3DJH
This information can be viewed to show you the status of the printer,
but it cannot be changed. To change these settings you must access
the printer’s configuration through the control panel of the printer, a
remote or local console, or CrownAdmin 3.
3ULQWHU6HWWLQJ
This table provides you with data relative to the settings of the printer.
Compatibility
Level
Identifies the PostScript emulation level.
Configuration Menu: No equivalent
Do Start-up
Page
Identifies whether the printer start-up page is
turned on or off.
Configuration Menu: Administration/Startup
Options/Do Start Page
Do Error
Handler
Identifies whether the PostScript Error Handler is
on or off. Error Handler is a diagnostic tool that
identifies PostScript errors encountered during a
print job.
Configuration Menu: Administration/Startup
Options/Do Error Handler
Do Sys/Start
Identifies whether the printer controller checks the
hard disk for a PostScript file named SYS\START
and then executes the file. This file does not print.
Configuration Menu: Administration/Startup
Options/Do Sys Start
Is Password
0?
Identifies whether the Administration menu
password is set.
0=Off
Configuration Menu: Installation/Use Admin Pwd
Duplex
Identifies whether the duplex option (if available) is
enabled.
Configuration Menu: Operator Control/Duplex