QPS Que! USB 2/1.1 Quick Install Manual - page 15
The NUMBER ONE cause of premature disc failure with recordable CDs is contamination of
the recording surface before recording is completed. To minimize disc failure, use the
following disc-handling guidelines.
•
Keep the media in its sealed package until you are ready to record.
•
Keep the disc as clean and dust-free as possible. DO NOT touch
the recording surface, and do not expose the disc to dust or dirt.
•
DO NOT BLOW ON THE DISC to remove dust or dirt. To remove
dust from the recording surface use a camera lens cleaner, a lint
free cloth or use compressed air. Wipe the disc from the center to
the outer edge. NEVER wipe the disc in a circular motion.
•
Always record in a dust-free environment. If the disc is to be
removed from the CD-RW drive, store the disc in a clean,
dust-free environment.
•
Never bend or flex the disc. This may warp the disc and leave it
unusable.
•
Never scratch off the reflective top surface of a CD-R or CD-RW
disc. Without the reflective surface the disc is completely unusable.
•
If you must write on the CD-R disc surfaced, read the back of the
CD-R jewel case for instructions.
Note: Please refer to the Que! USB 2 / 1.1 Installation Manual, located on your
Installation disc.
CARE IN HANDLING
13