QPS Que! USB 2/1.1 Quick Install Manual - page 9
USB 2 Insta l l at i o n
NOTE: Please be sure that your USB 2.0 Controller Card is installed correctly and
functioning properly according to the manufacturers instructions and specifications
prior to connecting the Que! USB 2 / 1.1 CD-RW drive.
Before you plug in your new Que! USB 2 / 1.1 CD-RW drive, you must run the
"TPPINST.EXE" driver file installer. This file is located in the "Drivers" folder on your install
CD that was in your kit. After installing the drivers, restart the system and plug in your
new Que! USB 2 / 1.1 CD-RW drive.
Step 1. Plug the power adapter into the wall receptacle and into the back of the drive.
Step 2. Plug the USB cable into the USB 2.0 port on the back of your USB 2.0 Controller
Card and into the port on the back of the drive.
Step 3. Let Windows 2000 detect your new Que! USB 2 / 1.1 CD-RW drive.
Step 4. Reboot your computer, this will only be necessary the first time you
install the drive.
Step 5. Verify that your new Que! USB 2 / 1.1 CD-RW drive is available for use within the
Windows operating system.
Step 6. Install the CD-Recording software that is supplied on your Install CD.
Note: Please refer to the Que! USB 2 / 1.1 Installation Manual, located on your Installation disc.
7
USB 2 INSTA L L AT I O N