QPS Que! Quick Start Installation Manual - page 13
The NUMBER ONE cause of premature disc failure with recordable media is contamination
of the recording surface before recording is completed. To minimize disc failure, use
the following disc-handling guidelines.
• Keep the media in its sealed package until you are ready to record.
• Keep the disc as clean and dust-free as possible. DO NOT touch the
recording surface, and do not expose the disc to dust or dirt.
• DO NOT BLOW ON THE DISC to remove dust or dirt. To remove dust
from the recording surface use a camera lens cleaner, a lint free cloth
or use compressed air. Wipe the disc from the center to the outer
edge. NEVER wipe the disc in a circular motion.
• Always record in a dust-free environment. If the disc is to be removed
from the DVDBurner drive, store the disc in a clean, dust-free environment.
• Never bend or flex the disc. This may warp the disc and leave it
unusable.
• Never scratch off the reflective top surface of recordable media..
Without the reflective surface the disc is completely unusable.
• If you must write on the recordable media disc surface, read the
back of the media jewel case or sleeve for instructions.
Note: Please refer to Que! DVDBurner Installation Manual CD for complete installation ver-
11
H A N D L I N G