Quadro MC-100 User Manual - Preparation For Use
- 3 -
ENGLISH
PREPARATION FOR USE
Unpacking and Setup
* Carefully remove the unit from the display carton and remove all packing material from the unit
itself.
* Remove any descriptive labels that may be found on either the front or top cabinet of the unit.
Do not remove any labels located on either the back or button cabinet of the unit.
Power Sources
Using AC Power
1. Check the Power voltage, as shown on the product Rating label on the unit bottom, corresponds
to you local AC Power Supply. If it does not, consult your dealer or service centre.plate
2. Connect the AC power into Standard household wall outlet.
3. To switch off unit completely, unplug the power cord from the wall outlet.
Unplug the power cord from the wall outlet to protect your set during heavy thunderstorms.
Batteries (not included)
1. Open the battery compartment and insert six batteries, Alkaline type LR14, UM-2 or C-cells with
the correct polarity as indicated by the ”+” and ”-” symbols inside the compartment.
Batteries contains chemical substances, so they should be disposed of properly. Incorrect use of
batteries can cause electrolyty leakage and will corrode the compartment or cause the batteries to
burst. Therefore:
- Do not mix a differenty types of the batteries, e.g. Alkaline with Carbon-Zinc types. Only use
batteries of the same type.
- When inserting new Batteries, do not try to mix old Batteries with new ones.
- Remove the Batteries if the set is not to be used for a long time.