Quadro MC-100 User Manual - Operation
Standby mode
After the unit is connected to the power source or the battery is inserted, it is
in standby mode; the clock is shown on the display. Press STANDBY button
to switch it on from the standby mode; the radio mode will be activated.
In the standby mode only clock function is available
Clock setting
In the standby mode press PLAY/PAUSE /TIME button on the device, the hour digits will blink;
Press BACK and NEXT buttons to set hours.
Press PLAY/PAUSE/TIME again, the minute digits will blink; press BACK and
NEXT buttons to set minutes. Press the TIME button again to confirm.
OPERATION
GENERAL OPERATIONS
ENGLISH
- 5 -
Power supply
Battery operation
Open the battery compartment cover. Insert 6 x 1.5V LR14, UM-2 batteries (not include).
Please observe correct battery polarity or the unit will not work.
Close the battery compartment cover.
When the batteries are exhausted, they should be replaced.
Do not recharge or heat the batteries.
Uncharged batteries are not a reason for contacting a repair service.
Disconnect power cord from the socket, when the unit is on battery
supply. Battery power is automatically disconnected when the power cord
is connected to a power socket.
AC operation
Before first plugging the appliance check that voltage indicated on the
rating label corresponds to the mains voltage in your home.
Insert the plug of the power cord into a power supply socket.