Electric fireplace heater i n s t r u c t i o n m a n u a l m850p-36acn ndf-65nb-1 attention: 1. Find a location for the fireplace heater that is protected from direct sunlight. 2. Do not plug the unit into the power outlet before you read all instructions..
2 s a f e t y i n s t r u c t i o n s important please note when you open the carton care- fully check the unit and make sure there are no damages. If you have any problems with the unit, with how the various functions work or with hidden damages or missing parts please call 1-800-459-4409 (est) im-...
3 8) do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it will not be tripped over. 9) to disconnect fireplace, turn controls to off, then remove plug from outlet. 10) connect to properly grounded outlets ...
4 heater. If the breaker trips when the heater is used then you may need to move the heater to another location or unplug other appliances that are on the same circuit. If you require an extension cord use one that is rated at 1875 watts. Save these instructions for future use. S a f e t y i n s t r...
5 mantel and insert assembly: warning: make sure the fireplace insert controls are in the off position and the insert is not plugged in. Caution: place a piece of cardboard or protective sheet on the floor in order to avoid scratching the decorative surface of your mantel during assembly. Please do ...
6 note: if the kd screw(s) do not fit during assembly, loosen the 2 screws to adjust the plastic connector until the panels/kd screws can be installed. Step 3: attach the side panels [c] to the left front panels [d] with 3 kd screws. Attach the other side panels [c] to the right front panels [g] wit...
7 step 8: attach 3 mounting clips [u] onto the top of insert and lock in place with 3 short kd screws [t]. See fig. H. Step 9: install the top panel [a] to the unit as shown and attach with 4 kd screws. See fig. I. Step 10: tighten all kd screws. Step 11: carefully move the assembled unit to the des...
8 o p e r a t i o n after reading complete instructions, confirm all controls on fireplace are in the off posi- tion. Plug the fireplace into a 15amp/120volt outlet. If the cord does not reach, you may use an extension cord rated for a minimum of 1875 watts. Once the fireplace insert has been proper...
9 dimmer control knob: turn the dimmer dial clockwise or counter clockwise to get the desired flame intensity. The dimmer switch can only be used when the o/i switch is in the on position. Note: when the on/off switch is turned off, all other heater functions will stop even though the switches may b...
10 option 1: use the spare kd nuts, kd screws and plastic connector 1. Place the plastic connector on the mantel unit and mark the drill-holes as shown in fig. B. Fig. B 2. Drill the holes with diameter 3/4 inches (10 mm) and depth 3/4 inches (10mm) on the mantel. Each plastic connector needs 3 hole...
11 4. Attach the plastic connector and lock in place with kd screws as shown in fig. E. Option 2: use the small l-brackets and screws. 1. Place the small l-bracket to the unit as shown and mark the drill-holes on the mantel as shown in fig. F. 2. Drill the holes with diameter 1/16 inch- es (2 mm) an...
12 warranty every electric fireplace heater is tested before it leaves the factory and it is guar- anteed for one year. If the unit should fail to operate correctly within one year from the date of purchase, call customer service at 1-800-459-4409 (est). We will, at our discretion either repair or r...
