Quality Craft M850P-36ACN Instruction Manual - page 5
5
MANTEL AND
INSERT ASSEMBLY:
WARNING: Make sure the fireplace INSERT
controls are in the OFF position and the
INSERT is NOT plugged in.
CAUTION: Place a piece of cardboard or
protective sheet on the floor in order to avoid
scratching the decorative surface of your
mantel during assembly.
Please DO NOT fully tighten the KD screws
until all panels are assembled.
Step 1: Attach 2 CONNECTOR [S] to the UPPER
FRONT PANEL [E] with 4 KD SCREWS.
(2 screws for each side) See Fig. A.
fig. A
Step 2: Attach all PLASTIC CONNECTOR [X]
to the PANELS [C, D, E and G] as shown in
Fig. B. (2 screws for each PLASTIC
CONNECTOR).
A S S E M B LY I N S T R U C T I O N S
PARTS LIST:
A) Top panel
1
B) Base panel
1
C) Side panel
2
D) Left front panel
1
E) Upper front panel 1
F) Lower front panel 1
G) Right front panel 1
S) Connector
2
T) Short KD screws 3
U) Mounting clips
3
V) Mounting brackets 2
W) KD screws
60
X) Plastic connector 16
Y) SELF REPAIR SET
Touch-up repair paint (bottle)
L shape bracket
2
Screws for L shape 8
Plastic Connector
1
KD Screws
3
KD Nuts
3
Z) WALL ANCHOR SAFETY
CABLE
Wall Anchor
1
Screw for wall anchor 1
Screw for mantle
1
Safety cable
1
TOOL REQUIRED: PHILLIPS HEAD SCREWDRIVER