Quality Craft M850P-36ACN Instruction Manual - page 6
6
NOTE: If the KD SCREW(S) do not fit during
assembly, loosen the 2 screws to adjust the
PLASTIC CONNECTOR until the PANELS/KD
SCREWS can be installed.
Step 3: Attach the SIDE PANELS [C] to the LEFT
FRONT PANELS [D] with 3 KD SCREWS. Attach
the other SIDE PANELS [C] to the RIGHT FRONT
PANELS [G] with 3 KD SCREWS. See Fig. C.
Step 4: Attach the LEFT and RIGHT SIDE PANELS
[C, D and G] to the BASE [B] using 4 KD SCREWS.
(2 screws for each side) See Fig. D.
Step 5: Place the LOWER FRONT PANEL [F]
in between the lower section of 2 FRONT
PANELS [D and G] and attach with 2 KD
SCREWS (1 screw each side). See Fig. E.
Step 6: Carefully place the INSERT into the
unit opening. The front of INSERT should
be flush with the front of the mantel. Once
the INSERT is in place, attach 2 MOUNTING
BRACKETS [V] with 2 KD SCREWS onto the
bottom of insert. (1 screw for each bracket)
See Fig. F.
Step 7: Attach the UPPER FRONT PANEL [E]
in between the upper section of the 2 FRONT
PANELS [D and G] with 6 KD SCREWS. (3
screws for each side) See Fig. G.
A S S E M B LY I N S T R U C T I O N S
fig. D
fig. B
fig. C
fig. E
fig. F