Quality Craft MM480PG-47CW Instruction Manual

Summary of MM480PG-47CW

  • Page 1

    1 important: please note when you open the carton carefully check the unit and make sure there is no damage. If you have any problems with assembling the unit, with how the various functions work or with damage or missing parts please call 1-800-459-4409 (9:00am - 5:00pm est) immediately for service...

  • Page 2

    2 control, a program controller, a timer or any other device that switches the heater on automatically, remember to observe all safety warnings at all times. The fireplace heater has safety overheat protection. If the overheat protection trips, switch off all switch buttons and wait approximately 5 ...

  • Page 3

    3 mantel assembly: caution: place a piece of cardboard or protective sheet on the floor in order to avoid scratching the decorative surface of your mantel during assembly. Do not fully tighten the kd screws until all panels are assembled. Step 1: attach all plastic connectors (x) to the panels (c, e...

  • Page 4

    4 fig. G fig. H step 8: tighten all kd screws [r]. Fireplace insert installation: the fireplace insert can be installed after the mantel has been fully assembled. Warning: make sure the fireplace insert controls are in the off position and the unit is not plugged in. Step 1: place the insert on the ...

  • Page 5

    5 fig. M once the fireplace heater has been properly installed to the mantel, plug the fireplace into a 15amp/120 volt outlet. If the cord does not reach you may use an extension cord rated for a minimum of 1875 watts. Note: every time the electric heater is plugged in, it will beep once. This means...

  • Page 6

    6 flame/log: press this button once for flame effect. The unit will be beep and the indicator light will be on. The bulbs for flame effect & log-set will be on. To adjust the flame intensity, hold down the button - the flame optics will go higher or lower. Once you have found the desired setting, re...

  • Page 7

    7 repairs if any problems are found with the original parts during mantel assembly such as the panels cannot be installed with the plastic connector. Try to solve by one of these following methods: tools required: electric drill, drill bits 3/4 inches (10 mm) or 1/16 inches (2 mm), pencil, hammer, p...

  • Page 8

    8 cleaning to clean unit first turn off controls on unit and unplug the unit from power source. To clean glass display panel; remove dust with clean dry cloth or to remove finger prints and other marks clean glass with clean damp cloth. Do not use abrasive cleaners or spray liquids on glass display ...