Quality Craft MM480PG-47CW Instruction Manual - page 3
3
MANTEL ASSEMBLY:
CAUTION: PLACE A PIECE OF CARDBOARD OR PROTECTIVE
SHEET ON THE FLOOR IN ORDER TO AVOID SCRATCHING THE
DECORATIVE SURFACE OF YOUR MANTEL DURING ASSEMBLY.
DO NOT FULLY TIGHTEN THE KD SCREWS UNTIL ALL PANELS
ARE ASSEMBLED.
Step 1: Attach all PLASTIC CONNECTORS (X) to the PANELS (C,
E, F, G and H) as shown in Fig. A. (2pcs KD SCREWS [R] for each
CONNECTOR).
Step 2: Attach the PILLARS (J) and DECORATIVE BOX (K) to the
LEFT and RIGHT FRONT PANEL (E and F) with 3 KD SCREWS [R]
as shown in fig. B.
Fig. A
Fig. B
Step 3: Attach the LEFT SIDE PANEL (G) to the LEFT FRONT
PANEL (E) with 2 KD SCREWS [R]. Attach the RIGHT SIDE PANEL
(H) to the RIGHT FRONT PANEL (F) with 2 KD SCREWS [R]. See
fig. C.
Fig. C
Step 4: Attach the LEFT (E, G) and RIGHT (F, H) SIDE PANELS to
the BASE (B) using 4 KD SCREWS [R] (2 screws on each side).
See Fig. D.
Fig. D
Step 5: Place the UPPER FRONT PANEL (C) over both FRONT
PANELS (E and F) and lock in place to the SIDE PANELS (G and H)
with 2 KD SCREWS [R] as shown in Fig. E.
Fig. E
Step 6: Attach the MID-FRONT PANEL (D) to the UPPER FRONT
PANEL (C) with 4 KD SCREWS [R] (2 screws each side). See Fig. F.
Fig. F
Step 7: Install the TOP PANEL (A) to the unit as shown and attach
with 4 KD SCREWS [R]. See Fig. G and H.