Quality Craft MM480PG-47CW Instruction Manual - page 7
7
REPAIRS
If any problems are found with the original parts during mantel
assembly such as the panels cannot be installed with the plastic
connector. Try to solve by one of these following methods:
Tools required: Electric drill, drill bits 3/4 inches (10 mm) or 1/16
inches (2 mm), pencil, hammer, Philips screwdriver, safety goggles
and gloves (if necessary).
WARNING: Wear goggles before you start drilling.
Option 1:
Use the spare KD NUTS, KD SCREWS and PLASTIC CONNECTOR.
1. Place the PLASTIC CONNECTOR on the mantel unit and mark
the drill-holes as shown in Fig. B.
Fig. B
2. Drill the holes with diameter 3/4 inches (10 mm) and depth 3/4
inches (10 mm) on the mantel. Each PLASTIC CONNECTOR needs
3 holes. See Fig. C.
Fig. C
Fig. D
3. Gently install the KD NUTS into the drilled-holes with hammer as
shown in Fig. D.
4. Attach the PLASTIC CONNECTOR and lock in place with KD
SCREWS as shown in Fig. E.
Fig. E
Option 2:
Use the SMALL L-BRACKETS and SCREWS.
1. Place the SMALL L-BRACKET to the unit as shown and mark the
drill-holes on the mantel as shown in Fig. F.
Fig. F
2. Drill the holes with diameter 1/16 inches (2 mm) and depth
5/16 inches (8 mm) on the mantel. Each SMALL L-BRACKET
needs 4 holes. See Fig. G.
Fig. G
Fig. H
3. Attach the SMALL L-BRACKET and lock in place with SCREWS
as shown in Fig. H.