Quality Craft MM650C-38ACH Instruction Manual - page 5
5
Step 9: Attach the corner piece [M] on the top panel [A] and attach with 6 small screws [S].
See Fig. I.
Fig. I
BACK
Step 10: Install the top panel [A] to the unit with 4 KD screws. See Fig. J.
Fig. J
BACK
Step 11: Tighten all screws. Fig. K.
Fig. K
BACK
FIREPLACE INSERT INSTALLATION:
The fireplace insert can be installed after the mantel has been fully assembled.
WARNING: MAKE SURE THE FIREPLACE INSERT CONTROLS ARE IN THE OFF
POSITION AND THE UNIT IS NOT PLUGGED IN.
Step 1: Place the insert on the floor, directly in front of the mantel. (the backs of both the mantel
and insert should be facing the same direction).
Step 2: Carefully lift the insert into the mantel opening. The front of the insert should be flush
with the front of the mantel.
Step 3: Once the insert is in place, attach 3 mounting clips [R] on the top of the insert and lock
the insert in place with 3 short KD screws [X]. See fig. L.
Fig. L
BACK
Step 4: Attach 2 mounting bracket [W] to the bottom with 2 KD screws. See fig. L.
Step 5: Move assembled unit to desired location. Unit should not be positioned in area exposed
to direct sunlight.
WALL ANCHOR SAFETY CABLE
The use of wall anchor safety cable is highly recommended in order to reduce the risk of the
fireplace being tipped over accidentally.
WARNING: THIS CABLE MAY REDUCE POSSIBLE RISK OF INJURY IF THE
FIREPLACE IS IMPROPERLY HANDLED, BUT IS NOT A SUBSTITUTE FOR PROPER
ADULT SUPERVISION. CHILDREN SHOULD NOT BE LEFT UNATTENDED NEAR
ANY HEATER.
1. Drill a 5/16 in (8 mm) hole in the wall. Insert the plastic wall anchor into the hole and gently
tap until the flange on the anchor is against the wall surface.
2. Position the back edge of the mantel close to the wall.
3. Attach the safety cable to the mantel using the screw for mantel. See figure M or N.
Fig. M
BACK
MM650C-38ACH_qualitycraft_walmart_com_fireplace-manual_2.indd 5
12-12-10 9:40 AM