Quality Craft MM650C-38ACH Instruction Manual - page 6
6
Fig. N
BACK
4. Use the screw for wall to attach the other end of safety cable to the wall.
5. Make sure all screws are tight.
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF position.
Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach, you may use an
extension cord rated for a minimum of 1875 WATTS. Once the fireplace insert has been
properly connected to a grounded electrical outlet, it is ready to operate.
OPERATION BY THE CONTROL PANEL
The controls are located behind the grill below the front glass and can be accessed by pulling
the grill from the top, forward and down.
WARNING: DO NOT TOUCH HOT SURFACE AT CENTRE OF GRILL, HANDLE, LEFT OR
RIGHT SIDE OF GRILL WHEN PULLING OUT.
ON/OFF: Press this button for main power and flame effect. The indicator light will turn
on. See below for other control switches.
750W: For low heat function, press this switch while the ON/OFF switch is in the on
position for low heat. The indicator light will turn on.
1500W: For high heat function, press this switch while the ON/OFF switch and the
750W switch are in the on position for high heat. The indicator light will turn on.
TEMPERATURE CONTROL: To adjust the temperature to your individual
requirements, turn the temperature control dial to the right (clockwise) to increase
the desired temperature and to the left for lower temperature. This temperature
control dial can only be used while the ON/OFF, 750W and 1500W switches are in
the ON position.
DIMMER CONTROL KNOB: Turn the dimmer dial clockwise or counter clockwise
to get the desired flame intensity. The dimmer switch can only be used when the
ON/OFF switch is in the on position.
NOTE: When the ON/OFF switch is turned off, all other heater functions will stop even
though the switches may be in the on position.
MAINTENANCE
WARNING:
DISCONNECT POWER AND UNPLUG THE POWER CORD BEFORE ATTEMPTING ANY
MAINTENANCE OR CLEANING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR
DAMAGE TO PERSONS. THE BULBS IN YOUR UNIT CAN BECOME EXTREMELY HOT.
ALLOW AT LEAST 10 MINUTES BETWEEN TURNING OFF THE UNIT AND REMOVING
THE LIGHT BULBS TO AVOID THE ACCIDENTAL BURNING OF THE SKIN.
RISK OF FIRE: DO NOT EXCEED THE RECOMMENDED BULB WATTAGE.
REPLACING THE LIGHT BULBS
Step 1: Remove 4 screws on the back of fireplace and open the rear cover.
Step 2: You will find 1x40W type B-10 bulbs under the log-set bed.
Step 3: Loosen and remove the burnt out bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the 4 screws.
Step 5: Plug in the unit.
REPAIR SET
MM650C-38ACH_qualitycraft_walmart_com_fireplace-manual_2.indd 6
12-12-10 9:40 AM