Quality Craft MM850P-28AHDW Instruction Manual

1

ElEctric FirEPlAcE 

HEAtEr

Model: MM850P-28AHDW

IMPORTANT:

PleAse NOTe: WHeN yOu OPeN THe cARTON, cARefully cHeck THe uNIT AND 

MAke suRe THeRe Is NO DAMAge. If yOu HAve ANy PRObleMs WITH THe uNIT, 

WITH HOW THe vARIOus fuNcTIONs WORk, OR HAve DAMAgeD OR MIssINg 

PARTs PleAse cAll 1-800-459-4409 (MONDAy TO fRIDAy, 8:30AM TO 5:00PM, 

esT) IMMeDIATely fOR seRvIce. 

NOTe: DO NOT ReTuRN uNIT TO THe sTORe befORe cAllINg THe TOll fRee 

NuMbeR. DO NOT DIsPOse Of yOuR cARTON uNTIl yOu ARe cOMPleTely 

sATIsfIeD WITH yOuR NeW fIRePlAce HeATeR. 

NOTE: Light bulbs may become loose during shipping. If the flame effect is dim or does 

not work, please check that light bulb or bulbs are finger tight in socket. See instructions for 

replacing bulb or bulbs. 

NOTE: The electric fireplace heater may emit a slight harmless odor when first turned on.  

This is caused by activating the internal heater components for the first time and should not 

occur again. 

iNStrUctiON MANUAl

ATTeNTION: 

1.   Find a location for the fireplace heater that is protected from direct sunlight.

2.  Do not plug the unit into the power outlet before reading all instructions.

iMPOrtANt SAFEtY iNStrUctiONS

WHeN usINg elecTRIcAl APPlIANces, bAsIc PRecAuTIONs sHOulD AlWAys 

be fOllOWeD TO ReDuce THe RIsk Of fIRe, elecTRIc sHOck, AND INJuRy TO 

PeRsONs, INcluDINg THe fOllOWINg:

1)   Read all instructions before using this electric fireplace heater.

2)   This electric fireplace heater is hot when in use. To avoid burns, do not let bare 

skin touch hot surfaces. The grill directly in front of the heater outlet becomes 

hot during heater operation. keep combustible materials, such as furniture, 

pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) away  

from the front of the unit and keep them away from the sides and rear. 

3)   extreme caution is necessary when any heater is used by or near children  

or individuals with disabilities and whenever the fireplace is left operating  

and unattended. 

4)   Always unplug fireplace when not in use.

5)   Do not operate any electric fireplace with a damaged cord or plug or after  

the heater malfunctions, has been dropped or damaged in any manner. 

6)   Do not use outdoors. 

7)   This electric fireplace heater is not intended for use in bathrooms, laundry 

areas and similar indoor locations. Never locate heater where it may fall into a 

bathtub or other water container. 

8)   Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or 

similar coverings. Arrange cord away from traffic area and where it will not be 

tripped over. 

9)   To disconnect fireplace, turn controls to off, then remove plug from outlet. 

10)  connect to properly grounded outlets only. 

11)   Do not insert or allow foreign objects to enter any ventilation or exhaust  

opening as this may cause an electric shock or fire, or damage the heater. 

12)   To prevent a possible fire, do not block air intakes or exhaust in any manner.  

Do not use on soft surfaces, like a bed, where openings may become blocked. 

13)  A heater has hot and arcing or sparking parts inside. Do not use it in areas 

where gasoline, paint, or flammable liquids are used or stored. 

14)  use this fireplace heater only as described in this manual. Any other use not 

recommended by the manufacturer may cause fire, electric shock, or injury  

to persons. 

15)  Avoid the use of an extension cord because the extension cord may overheat 

and cause a risk of fire. However, if you have to use an extension cord, the cord 

shall be No.14 AWg minimum size and rated not less than 1875 watts. 

16)  Do not plug this product into a receptacle controlled by a wall switch  

or dimmer.

17)  When storing or transporting the unit and cord, keep in a dry place,  

free from excessive vibration and store so as to avoid damage.

SAVE tHESE iNStrUctiONS  

FOr FUtUrE USE.

cAuTION:

If yOu use THIs HeATeR IN cONJuNcTION WITH A THeRMAl cONTROl, A 

PROgRAM cONTROlleR, A TIMeR OR ANy OTHeR DevIce THAT sWITcHes THe 

HeATeR ON AuTOMATIcAlly, ReMeMbeR TO ObseRve All sAfeTy WARNINgs 

AT All TIMes. THe fIRePlAce HeATeR HAs sAfeTy OveRHeAT PROTecTION. 

If THe OveRHeAT PROTecTION TRIPs, sWITcH Off All sWITcHes AND WAIT 

APPROxIMATely 5–10 MINuTes. IT sHOulD ReseT AuTOMATIcAlly ONce THe 

uNIT cOOls DOWN.

WARNINg:

PROceDuRes AND TecHNIques, If NOT cARefully fOllOWeD, WIll ResulT 

IN DAMAge TO THe equIPMeNT, AND WIll exPOse THe useR TO THe RIsk Of 

seRIOus INJuRy, IllNess OR DeATH. 

THIs elecTRIc fIRePlAce HeATeR Is fOR use ON 120 vOlTs. THe cORD HAs 

A Plug As sHOWN AT A IN IllusTRATION belOW. AN ADAPTeR As sHOWN AT 

c Is AvAIlAble fOR cONNecTINg THRee-blADe gROuNDINg-TyPe Plugs TO 

TWO-slOT RecePTAcles. THe gReeN gROuNDINg Plug exTeNDINg fROM 

THe ADAPTeR MusT be cONNecTeD TO A PeRMANeNT gROuND sucH As A 

PROPeRly gROuNDeD OuTleT bOx. THe ADAPTeR sHOulD NOT be useD If A 

THRee-slOT gROuNDeD RecePTAcle Is AvAIlAble. 

A 15 AMP cIRcuIT Is RequIReD TO OPeRATe THIs HeATeR. If THe bReAkeR 

TRIPs WHeN THe HeATeR Is useD, yOu MAy NeeD TO MOve THe HeATeR TO 

ANOTHeR lOcATION OR uNPlug OTHeR APPlIANces THAT ARe ON THe sAMe 

cIRcuIT. If yOu RequIRe AN exTeNsION cORD, use ONe THAT Is RATeD AT 

1875 WATTs.