Quality Craft MM850P-28AHDW Instruction Manual - page 4
4
Step 6: Attach top panel [A] on top with 3 KD screws. See fig. F.
Fig. F
bAck
Step 7: Tighten all KD screws.
FirEPlAcE iNSErt iNStAllAtiON:
The fireplace insert can be installed after the mantel has been fully assembled.
WARNINg: MAke suRe THe fIRePlAce INseRT cONTROls ARe IN THe Off
POsITION AND THe uNIT Is NOT PluggeD IN.
Step 1: Attach two mounting feet [Q] to the fireplace insert (one at each side) with 8
screws for mounting feet [R] (4 screws for each mounting foot). See Fig G.
Fig. G
bAck
Step 2: Carefully place the insert in the unit opening. The front of insert should be flush
with the front of the mantel. Carefully lift the insert into the mantel until the top
stopper is against the mantel.
Step 3: Attach 2 mounting clips [U] to the top side of insert with 2 short KD screws [T].
Attach 2 mounting brackets [V] to the feet of insert with 2 KD screws.
See Fig H.
Fig. H
bAck
Step 4: Move assembled unit to desired location. Unit should not be positioned in area
exposed to direct sunlight.
WAll ANcHOr SAFEtY cABlE
The use of wall anchor safety cable is highly recommended in order to reduce the risk of the
fireplace being tipped over accidentally.
WARNINg: THIs cAble MAy ReDuce POssIble RIsk Of INJuRy If THe
fIRePlAce Is IMPROPeRly HANDleD, buT Is NOT A subsTITuTe fOR PROPeR
ADulT suPeRvIsION. cHIlDReN sHOulD NOT be lefT uNATTeNDeD NeAR
ANy HeATeR.
1. Drill a 5/16 in (8 mm) hole in the wall. Insert the plastic wall anchor into the hole and gently
tap until the flange on the anchor is against the wall surface.
2. Position the back edge of the mantel close to the wall.
3. Attach the safety cable to the mantel using the screw for mantel. See figure I.
Fig. i
bAck
4. Use the screw for wall to attach the other end of safety cable to the wall.
5. Make sure all screws are tight.
OPErAtiON
After reading complete instructions, confirm all controls on fireplace are in the OFF position.
Plug the fireplace into a 15AMP/120Volt outlet. If the cord does not reach, you may use an
extension cord rated for a minimum of 1875 WATTS. Once the fireplace insert has been
properly connected to a grounded electrical outlet, it is ready to operate.