Quality Craft MM850P-28AHDW Instruction Manual - page 2
2
PArtS liSt:
Fireplace insert..................................................................................................... 1
A) Top panel ........................................................................................................ 1
B) Base panel ...................................................................................................... 1
C) Upper front panel ............................................................................................. 1
D) Lower front panel ............................................................................................. 1
E) Left front panel ................................................................................................ 1
F) Right front panel .............................................................................................. 1
G) Left upper side panel ....................................................................................... 1
H) Right upper side panel ..................................................................................... 1
J) Left lower side panel ........................................................................................ 1
K) Right lower side panel ...................................................................................... 1
Q) Mounting Feet ................................................................................................. 2
R) Screws for mounting feet ................................................................................. 8
S) 4-HOLE WOOD CONNECTORS ......................................................................... 4
T) Short KD screws .............................................................................................. 2
U) Mounting Clips................................................................................................. 2
V) Mounting Brackets ........................................................................................... 2
W) KD screws ..................................................................................................... 53
X) Plastic Connectors ......................................................................................... 11
Y) SELF REPAIR SET
Touch-up repair paint (bottle) ............................................................................ 1
L shape bracket ................................................................................................ 2
Screws for L shape ........................................................................................... 8
Plastic connector .............................................................................................. 1
KD screws ........................................................................................................ 3
KD nuts ............................................................................................................ 3
Z) WALL ANCHOR SAFETY CABLE
Wall anchor ...................................................................................................... 1
Screw for wall anchor ....................................................................................... 1
Screw for mantel .............................................................................................. 1
Safety cable ..................................................................................................... 1
TOOLS REQUIRED: PHILLIPS SCREWDRIVER
MANtEl ASSEMBlY:
cAuTION: Place a piece of cardboard or protective sheet on the floor in order to avoid
scratching the decorative surface of your mantel during assembly.
Please DO NOT fully tighten the KD screws until all panels are assembled.
NOTe: Each plastic connector is pre-assembled (pre-drilled) on the specific panels with
2 screws. If the KD screw(s) do not fit during assembly, loosen the 2 (pre-drilled) screws to
adjust the plastic connector until the KD screws are able to be installed. Tighten all KD screws
once all panels are assembled.
Step 1: Attach 11 plastic connectors [X] to panels C, E, F, G, H, J and K as shown in
Fig. A (2 pcs KD screws for each plastic connector). Attach panels H and K
together with 4-hole wood connector [S] and 4 KD screws. Attach Panels G and
J together with 4-hole wood connector [S] and 4 KD screws. See Fig A.
Fig. A
bAck