QUANTA 230W Security Floodlight Installer's Manual - Section Five
SECTION FIVE
TECHNICAL SPECIFICATIONS
Detection Range
Detection Angle
Power Supply
Maximum Switchable Load
Lamp Type
Timer Control
Time On Adjustment
Lux Level Adjustment
Environmental Protection
Up to 12 metres
180º
240V ~ 50Hz
300W
118mm Linear Tungsten Halogen 300W max (R7S cap)
Adjustable 1 to 8 Hrs
5 seconds - 5 minutes
Day & night or night only operation
IP44 (suitable for outdoor use)
Halogen Lamp Replacement
CAUTION
Always handle quartz halogen bulbs with a soft cloth. Do not touch the bulb with your bare hand,
as it will shorten the life of the bulb.
1. Switch off the floodlight. Do not touch the Floodlight while it is in use or still hot. Allow it to cool
(about 5 minutes) before touching it.
2. Replacement bulb type is 240V mains halogen Max 300W R7S cap floodlight bulb.
3. Isolate the mains supply and then unfasten the glass cover.
4. Open the glass cover. The cover is mounted on hinges and will swing open.
5. To remove existing bulb, depress then lift one end of the bulb to remove.
6. Install new bulb by inserting one end first and depressing gently until enough clearance is
gained to seat the other end in the socket. Rotate the bulb to ensure it is properly seated.
7. re-fasten the clip to hold the cover in place.
Warning! In the event of the cover glass shattering, do not replace with normal household glass.
Do not operate without the glass shield in place. If the glass shield is cracked or damaged, it
must be replaced. If the glass is replaced, use only tempered glass of equal thickness