Quantum DLTtape SDLT 320 Supplementary Manual - page 8
Installing an SDLT or DLTtape Tape Drive into an HP-UX System
8
November 2002
6464118-01
5.
Unpack the patch. Be sure to use the appropriate command for your operating system
version. For example:
sh ./<PATCH>
Where
<PATCH>
is the patch name.
6.
Follow the instructions in
/tmp/
.
7.
Reboot your system, if necessary.
Installation complete.
Note:
After the patches are installed, your system may need the appropriate
tape driver included in the HP-UX kernel. D and K class HP9000/800
systems have a High Speed Connect (HSC) bus included in the
system. If the DLTtape drive is attached through the HSC, then the
stape
driver must be included in the kernel. In all other cases, attach
the tape drive through the Native I/O (NIO) bus; this requires the
tape2
driver. Use HP’s SAM utility to install the appropriate driver.