Quantum FastStor 1 Install Manual - page 9
62-0125-01
FastStor Rack Mount Installation Instructions
7
Installing Kit Components
1. Mount the left-hand inner slide rail (#15) to the FastStor using two slotted, pan head screws (# 3) as shown below.
Note: If the rear mounting-hole on the chassis is not threaded, you have an early rack-ready model. Perform the procedure
detailed in Appendix A: Side Rail Attachment for Early Model FastStor, then return to the next step in this procedure.
Refer to the illustration below while performing Steps 2 through 6.
2. Fasten the support box (#1) and your FastStor together using two philips, pan head screws (#19) at the front and rear of the
unit, and a philips, pan head screw (#8) with a Kepnut (#9) at the lower front of the unit. You must reach inside the front of
the FastStor and hold the Kepnut in place when installing the philips, pan head screw (#8). The upper mounting hole for the
front screw (#19) and the rear screw (#19) is threaded on the FastStor, and a Kepnut is not required.
3. Using a T-8 Torx driver, remove the upper and lower button head screws (#7) located at the front of the left side of the
FastStor.
4. Mount the left-hand front bracket (#16) to the left side of the FastStor using the two button head screws (#7) removed from
your FastStor during the previous step.
5. Remove the two button head screws (#7) located at the front on the right side of the support box. Mount the right-hand
bracket (#16) to the right side of the support box using the two button head screws (#7). Be sure that the thumbscrews are
positioned at the bottom as shown in the illustration above.
6. Using a #1 philips screwdriver, install the top cover (#2) to the support box using the 10 philips, flat head screws (#5).
The next step in the process is to install the FastStor into your rack. Follow the instructions in the section titled Installing the
FastStor/Support Box Assembly into the Rack later in this document.
15 Inner Rail
3 2 Places
Rear
Mounting Hole
1
2
5 (x 10)
16 (LH)
16 (RH)
19
19
9
8
Front
Mounting Hole