Quasi MX-1004 User Manual - Operation Software
~ 8 ~
It is CRITICAL to have the DVI-to-DVI cables connected to the CONN1-CONN1 & CONN2-CONN2 sockets on
the MX-1004 for normal operation & firmware update. Please have the bridge connectors linked at any time.
System Requirement and Precautions
1.
The MX-1004 provides a software control program, Quartet, which runs under Microsoft Windows 98, 2000,
XP, Vista through the interface of RS-232 serial control.
2.
Before you click on the icon of the software, make sure you have secured the connection between your
computer COM port and the MX-1004 and switched on the MX-1004 with green LED light.
3.
The MX-1004 has remote control and software control. To make sure all information shown in the software is
synchronized with those in the device, please click the update button to acquire the latest data from the
MX-1004 after you press any key on the remote control.
Instruction of Software Connection
1.
Power up the MX-1004 and you can see both red and green LEDs on the front panel blink. Make sure the
serial port (RS-232) connection secure.
2.
The first step after running the software is to automatically detect if the device responses correctly through
RS-232 port. First of all, choose the correct COM port from the Com Port selection list . Then, click
on the linkage button to open the COM port. If the specified COM port is not available, the following
error message window shows up. Please check the availability of COM Port. After the COM port is accurately
established, please click on status update button . A warning message will show up as the figure below if
the serial connection is not successfully detected.
COM Port Not Available Device Not Ready