Quasi MX-1004 User Manual - Inputs And Outputs
~ 5 ~
Inputs and Outputs
The MX-1004 has 10 inputs and accepts both graphics and video signals, which come from computers (DVI or
VGA), composite, and component video sources respectively. You can pick up four of the ten inputs and then
display four of them simultaneously on the same screen. Figure 2 shows the rear panel connectors of a MX-1004
and Table 1 illustrates how you can connect video devices and display to the MX-1004.
*Default: Turn on the MX-1004 then switch both three DIP switches simultaneously up and down
to factory default mode.
*These IO ports support various resolution from 640x480 up to 1920x1200, for more detail of
the supported modes, please refer to the Appendix – Supported Resolution.
Table 1: Input/Output Connectors
Input Connector
Video Source
DVI-x
YPbPr-x/VGA-x
[x = 1~3]
[1] DVI
[2] VGA — with a DVI-to-VGA adapter (DVA01)
[3] Component (YPbPr) — with a DVI-to-VGA adapter (DVA01) and a VGA-to-component
breakout cable (VYPBA01)
[4] 1x DVI + 1x VGA — with a DVI-to-DVI/VGA breakout cable (DDVY01)
[5] 1x DVI + 1x Component (YPbPr) — with a DVI-to-DVI&VGA breakout cable (DDVY01)
and a VGA-to-component breakout cable (VYPBA01)
VGA-4
[1] DVI
[2] VGA — with a DVI-to-VGA adapter (DVA01)
CVBS-1 ~ CVBS-4
[1] Composite — with a RCA cable
Bridge Connector
2x DVI*
Output Connector
Display
DVI-I OUT
[1] DVI display
[2] VGA display — with a DVI-to-VGA adapter (DVA01)
[3] 1x DVI display + 1x VGA display — with a DVI to DVI&VGA breakout cable (DDVY01)
It is CRITICAL to have the DVI-to-DVI cables connected to the CONN1-CONN1 & CONN2-CONN2 sockets on the
MX-1004 for normal operation & firmware update. Please have the bridge connectors linked at any time.
Figure 2: Rear Panel