Quest Engineering HPI 110 User Manual - page 12
HPi
110 &
HPi
210
Quick Rig (QR) Systems
User Manual
HPi110 & HPi210 Quick Rig (QR) Systems
10
Installation of the Spine on the HPi110
NOTE: The 2 x M10 bolts supplied with both the i-Spine and t-Spine should replace the
previously installed screws in the speaker . The M10 bolts are designed with a longer thread
which provides increased strength and security to the system .
Primary Applications Include:
• Wall Mount applications where tilt is
not needed
• Vertically Arraying 2 Speakers
The touring Spine (t-Spine) is
recommended for a precise and easy
hanging setup of the speaker when
used when flying a single speaker .
The holes, on each side, allow for a 5o
stepped tilt of the cabinet [from -15o
to +45o]
Only one rated shackle is necessary
to use the Spine in most applications .
(A quick-pin is also included with the
t-Spine)
The t-Spine can also be used as part of
a more complex rigging system .
Ordering reference:
ACHPiATS
Remove the 2 top
screws that are
installed in the speaker
then insert the lip of
the Spine to grab the
casing handle .
Swing it flat on the
top of the speaker .
Bolt in and secure
(using Loctite or similar
fastener securing
compound) the Spine
onto the speaker with
the 2 x M10 bolts
included .
1
2
3