Quest Engineering HPI 110 User Manual - page 13

HPi

110 & 

HPi

210 

Quick Rig (QR) Systems

User Manual

HPi110 & HPi210 Quick Rig (QR) Systems

11

Installing an HPi110 becomes easy with the 

QR wall-mounting system . 

Once the spine has been installed (as 

described above) install the wall-mount as 

follows: 

1 .   Bolt the wall mount assembly (without 

the speaker attached) onto the wall .

2 .   Lift the speaker (now installed with 

Spine) and hook it onto the wall-mount . 

The wall-mount is designed to safely 

support the weight of the box from this 

point .

3 .   Set the angle by sliding the quick-pin 

into the right hole (see next section for 

angles) .

HPi110 with 

i-Spine

Fixed hook 

assembly

HPi110 with Kit QR2 Standard

HPi110 with Kit QR2 Long Side Plates

7 .5 degrees

15 degrees

30 degrees

0 degrees

Setting the Angle of the Cabinet

Once the speaker has been mounted correctly, the angle at which the speaker will be fixed can be 

adjusted by fitting the Q-Pin into the correct hole . Four angles are available:

The standard kit offers the possibility to hang 

a speaker at 0˚ and 7.5˚.

If extra tilt (15˚ or 30˚) is needed, optional 

extension plates can be purchased separately 

and inserted in the wall-mount assembly .