Quest Engineering QM 1000P User Manual - page 8
QM
1000P
User Manual
User Manual
Q Motion Series
QM 1000P
6
DO NOT OPEN
RISK OF ELECTRIC SHOCK
CAUTION
Rear Panel Layout
1 . Satellite high pass crossover
The satellite speakers can be powered with full
range signal or a cross-over to sub frequency of
80Hz or 120Hz can be selected . For 8” speakers,
120Hz is suggested . When using 10”-12” speakers,
80Hz is be preferable and high powered 12” or 15”
speakers can be set to full range .
2 . Inputs
Connect signal leads from your mixer (master
left/right, line out, to the balanced inputs using
XLR mic leads . XLR connectors to be wired as
follows: 1 ground, 2 +, 3 - .
2
1
3
3
3 . Outputs
Speakon output connectors on rear wired L&R
pin 1+ pin1- . Neutric NL4 or NL2 connectors
are recommended . The total impedance per
output should not be below 4Ω (Ohms)
(3 .7Ω DC resistance) . 2 x 8Ω satellite
speakers and 1 x 8Ω bass speakers can be
connected per amplifier output .