Quickie Attitude Owner's Manual - page 12
MK-100393 Rev. A
12
Q UI CK I E A T T I T UD E
G. DOCKING THE ATTITUDE
WARNING
If the bike has a power system, always make sure the power switch is off before docking. Dock the wheel-
chair to the bike on a surface that is level and dry. As with all moving parts, there is a risk that fingers
and/or clothing could become trapped. Be careful of pinch points when docking, or undocking.
1. Engaging the docking pins.
a. Drive the wheelchiar as close as possible to the Attitude.
b. The two docking pins(A) should line up with the lower docking connector(B).
c. Engage the wheel locks on your chair, and pull the Attitude towards the wheelchair using the hand-
grip(C) until the two docking pins lock into the docking connector(B)
. An audible click will be heard.
2. Locking the wheelchair to the Attitude.
a.
b.
Push the Attitude upwards/forwards until the stand wheels(D) and the castors(E) leave the ground.
Swing the upper docking connector(F) on both sides, downwards until it stops. Clamping must be
on the aluminum tubing with no parts or clothing in the clamping area.
c. Pull the red locking levers(F) towards the rider until it locks firmly and completely.
d. Ensure that the docking pins are fully engaged, and the levers are locked before travel.
WARNING
Always make sure after locking the wheelchair to the Attitude, that the stand wheels(D) are a minimum
of
1.25in (30mm) above the ground. If they are not, they stand wheels will need to be adjusted. If not
properly adjusted the wheels could hook onto
an obstacle unexpectedly and cause the wheelchair and
Attitude to become unstable.
H. UN-DOCKING THE ATTITUDE
WARNING
If the bike has a power system, always make sure the power switch is off before undocking. Undock on a
surface that is level and dry. As with all moving parts, there is a risk that fingers and/or clothing could
become trapped. Be careful of pinch points when docking, or undocking.
1. Unlocking the two units.
a. Engage the wheel locks on your wheelchair.
b. Open the red locking levers(F) on both sides.
c. Using the handgrip (C), push the Attitude forwards/upwards until the upper docking connector has
no contact with the front frame or the wheelchair.
d.
Swing the upper docking connector(F) upwards.
2. Disengage the locking pins.
a. Lower the Attitude forward/upward until the stand wheels(D) and the castors(E) are in contact
with the ground.
b. Pull the locking pin release lever by the handgrip(G).
c. Using the handgrip(C) pull the Attitude towards you until the docking pins are totally disengaged.
d. Hold the position and push the Attitude forward away from the wheelchair, until it is clear of your
wheelchair.
13
12
11
13
12
11
10
12
11
10
9
9
10
11
G
C
A
E
12
VIII. USE AND MAINTENANCE
13
B
D
F
Locked