QuickLink SCADA PRO 900 User Manual - page 14
SCADA PRO 900 WIRELESS DATA MODEM
___________________________________________________________________________________________
Revision A
USER’S GUIDE
14
Code Upgrading
The SCADA PRO 900 has been designed for easy field upgrades. Using the RS-232
Serial Adapter board, a CDR-915 Family Programming cable, a standard Serial
Configuration cable and a current version of the CDR-915 Configuration program
running on the user’s PC, the radio can be re-flashed with new operating code. Special
customer code can also be loaded in this manner.
With the radio mounted on an RS232 Serial Adapter board, connect a program upgrade
cable from the programming connector, J4, on the Adapter board to the parallel port on
the PC. Connect a standard DB9 male-to-female serial cable from the Adapter board’s
DB9, J2, and to the serial port on the PC. Power the Adapter board using the supplied
9-volt wall module connected to the Adapter board’s power jack, P8.
Using the CDR-915 Configuration program, click on the Flash tab. Select the desired
software version from the Software Version drop-down box and then press the Program
Flash button. The Configuration program will then read the setup information from the
radio, upgrade the radio code and reload the original configuration.
Flash Upgrade Tab