QuickLink SCADA PRO 900 User Manual - page 22
SCADA PRO 900 WIRELESS DATA MODEM
___________________________________________________________________________________________
Revision A
USER’S GUIDE
22
0x000A = CTS Deassert Limit (Valid range = 1 - 178. Default = 178. This value should
be greater than the CTS Assert Limit.)
0x000B = CTS Assert Limit (Valid range = 1 - 177. Default = 89. This value should be
less than the CTS Deassert Limit.)
0x000C = Baud Rate (*See below for proper settings.)
0x000D = Ack-Back™ Enable (Valid range = 1 is enabled, 0 is disabled.)
0x000E = Ack-Back™ Retries (Valid Range = 0 - 255.)
0x000F = Ack-Back™ Timeout (Valid Range = 50 - 255.)
0x0010 = Communications Port (Valid range = 0 is SPI port, 1 is UART.)
0x0011 = Number of Repeaters in System (Valid range = 0 - 255.)
0x0012 to 0x1FF = Non-volatile User Data Storage
DR915 Repeater Address Map:
0x0001 = Not used
0x0002 = Preamble Bytes (high byte) (Valid range = 266 - 1000. Default = 266. A
value of less than 266 will cause improper operation.)
0x0003 = Preamble Bytes (low byte)
0x0004 = Group 1 (Valid range = 0 – 255.)
0x0005 = Group 2 (Valid range = 0 – 255.)
0x0006 = Baud Rate (*See below for proper settings.)
0x0007 = Debug Enable (Valid range = 1 is enabled, 0 is disabled.)