Quidway V100R006C00 Configuration Manual - 3.6 Configuration Examples
display stack configuration
Current slot-id Next slot-id Current Priority Next Priority
---------------- ------------- ---------------------- -------------
0 8 200 200
1 3 150 150
3.6 Configuration Examples
This section provides an example for configuring a stack in a ring topology.
3.6.1 Example for Configuring a Stack in a Ring Topology
Networking Requirements
, Switch A, Switch B, Switch C, and Switch D form a stack in a ring
topology. The stack system is automatically created. Switch A functions as the master switch,
whereas Switch B functions as a standby switch. After the active/standby switchover, the MAC
address of the stack system is immediately switched. To avoid updating MAC addresses of the
stack system frequently and wasting system resources, set the MAC address switchover time of
the stack system to 1 minute after the active/standby switchover.
Figure 3-5
Networking of a stack in a ring topology
SwitchA
SwitchC
SwitchD
SwitchB
stack link
common link
Configuration Roadmap
The configuration roadmap is as follows:
l
Configure the MAC address switchover time of the stack system on the master switch.
Data Preparation
To complete the configuration, you need the following data:
l
Service interfaces that need to be configured as stack interfaces on the master switch
l
Member interfaces to be added to the stack interfaces on the master switch
Quidway S6700 Series Ethernet Switches
Configuration Guide - Device Management
3 Stacking
Issue 02 (2011-10-01)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
37