Quik N’ Crispy GF – II Operator's Manual - page 16
©2006 QNC, Inc. 0106 Operator’s Manual
15
REPROGRAMMING THE MENU TEMPERATURE AND / OR TIME
SETTINGS
To adjust pre-programmed settings for any or all of the menus you must do the
following procedure.
Step 1. Push the On/Off Switch to the right "Power On" position. The digital
display should illuminate and display “IdLE”.
Step 2. Simultaneously press buttons 3 and 6 until "M 1" (Menu 1) appears on
the display. The controller is now ready to be reprogrammed. If Menu 3 or Menu
6 commences, and displays "PrE-HEAt", this is because the buttons were not
pushed simultaneously. Continue to depress both menu buttons until the program
is canceled and you enter into the programming mode.
Step 3. To select the menu that you wish to reprogram, and to move from Menu 1
to Menu 2, to Menu 3, and so on, press button 3, the "Up" key. To move down
the list of menus press button 6, the "Down" key.
Step 4. To change the settings for a specific menu, move up or down to the menu
that you wish to modify. With the appropriate menu displayed, press button 1, the
"Edit" key. The menu selected will now flash back and forth between "StPt 1"
(temperature set point) and the temperature programmed for the selected menu.
The controller is now ready to be reprogrammed.
Step 5. If you wish to change the individual menu cooking times, and not the
cooking temperatures, please skip to Step 6. If you wish to change the cooking
temperature for this menu selection, press button 1, the Edit Key again. The
temperature programmed for that menu will illuminate continuously. Then use
buttons 3 and 6 to move up or down to the desired new temperature. When you are
at the desired temperature, press button 2, the "Enter" key once. This will enter
into memory the new temperature that you selected.
Step 6. If you desire to change the cooking time for the selected menu at this
time, then follow the directions up to Step 4. With the display flashing back and
forth between "StPt 1" and the temperature programmed for the selected menu,
press button 6, the "Down" key, once. The digital display flash will now
intermittently flash between "tinE 1" (Time 1) and the time that is programmed
for that menu.