Quilter 101 Mini Reverb User Manual - page 11

11

AMPLIFIER MODULE SPECIFICATIONS

Power Output:

0 to  50 watts maximum, 4-8 ohms

AC Power Req.:

100–240Vac, 50–60 Hz, 100 W maximum

Input Connections:

¼" mono, 2M input impedance, 2V peak.

Effects Send:

¼” mono, 1V full scale, 600 ohms.

Effects Return

¼” mono, 1V full scale, 47K

Headphone Output

1/4" jack, 4V peak.

Speaker 1 Output:

8 ohms, 60-100 W recommended rating

Speaker 2 Output:

4 ohms, 60-100 W recommended rating

Dual Speakers 1+2

8 ohms each, 30-50W recommended rating. 

DIMENSIONS

H x W x D

8.5”(218mm) x 7.5” (190mm) x 3” (76mm)

Weight

4.5 lbs (2kg)

SPECIFICATIONS:

TROUBLESHOOTING:

Circuitry used in Quilter amplifiers is stable and there are no internal connec-

tions that might go bad. Generally, the amp works normally, or it doesn’t pass 

a signal at all, or in rare cases noises or dropouts occur due to cracked parts. 

Movable parts such as controls and inputs can be damaged or corroded, but 

these faults are usually apparent when cycling controls or re-inserting inputs. 

Most faults are traced to external causes such as cables, speakers, or in-

struments. The following troubleshooting chart should help narrow down the 

cause. 

Symptom

Action

No power, no lights

• Ensure that the AC cord is fully seated and 

connected to a live source.

• Check the AC source by trying another device.

Amp shuts off then after a 

short time, turns back on

• If amp feels very hot, thermal protection is 

activating. Reduce Master at least 30% and keep 

the amplifier out of direct sunlight or enclosed 

spaces. Amp normally runs only slightly warm.

• Continued intermittent behavior indicates need 

for servicing.