Quilter 101 Mini Reverb User Manual - page 9
REAR PANEL – AC POWER, SPEAKERS
International Power Supply
The 101 Mini Reverb works with all known worldwide AC voltages (100-250V),
which allows you to play just about anywhere on the planet.
IEC Power Cord
Connect a single 8 or 16-ohm speaker to the lower jack,
8-OHMS.
Connect a single 4-ohm speaker to the upper jack, marked
4-OHMS.
For two 8-ohm speakers, or any other mix of impedances,
plug one into each jack. Power will divide between the two
speakers. The amplifier will not be bothered by impedance mismatches, so if
the tone sounds OK, go for it!
CAUTION: The 101 can provide enough output to burn out low power speak-
ers, especially those built as exact re-issues of vintage 15-30W speakers. For
safer results, use the MASTER to select a wattage limit that is equal or less
than the speaker being used.
9
Plug the power cord that comes with your ampli-
fier into the AC inlet on the rear. Any 3-prong IEC
cord may also be used with the amplifier. Always
ensure that the ground contact is intact on both
the cord and receptacle.
Speaker Outputs