Quilter Pro Block 200 Owner's Manual - page 8
Pg. 8
ELECTRONIC PERFORMANCE
Power Output:
0 to 200 watts, 4-8 ohms
AC Power Req.:
100-240Vac, 50-60Hz, 250W
Input Connections:
1/4" mono
Direct Out:
XLR-M, 300mv full scale, balanced, ground lifted
10K min.
Speaker 1 Output:
8 ohms, 200 W minimum recommended rating
Speaker 2 Output:
4 ohms, 200 W minimum recommended rating
DIMENSIONS
H x W x D
2.5” (6.35cm ) x 8.4” (21.3cm) x 7.2” (18.3cm)
Weight
4 lbs (1.8kg)
Symptom
Action
No power, no lights
• Ensure that the AC cord is fully seated and
connected to a live source.
• Check the AC source by trying another device
such as a lamp.
Amp shuts off then after a
short time, turns back on
• Automatic thermal protection is activating.
Reduce the volume at least 30% and keep the
amplifier out of direct sunlight or tightly enclosed
spaces.
• Continued intermittent behavior indicates need
for servicing.
No audio (using a guitar)
• Confirm that the MASTER control and the GAIN
controls are turned up.
• Ensure the guitar plug is inserted fully at each
end.
• Try using a different guitar cable.
• Check that the pickup selector switch and volume
on the guitar are set correctly.
• Ensure that the rear panel speaker plug is fully
inserted into the INT SPEAKER jack.
Weak or fluctuating audio
• Check connections and power supply or batteries
in pedal board.
• The amplifier almost never “loses power” without
completely stopping. Look for external causes.
SPECIFICATIONS:
TROUBLESHOOTING: