Quintum Tenor AX Product Manual - page 52

P/N 480-0062-00-10

3-17

Chapter 3: Installation/Basic Troubleshooting

2. At the prompt, enter the IP address for your unit and enter the default login and password  (admin/

admin).

3. At the Phone(FXS)/Line(FXO)> AnalogInterface-Line screen, enable all four lines (or two lines, depend-

ing upon the unit type) under FXO Channel Assignment. Click on Confirm/OK.

4. At the System-Wide Configuration> Dial Plan screen, enter an Area Code (default is 732) and check Use 

10 Digit Local Dial. Clickon Confirm/OK. 

Allows the unit to use the 732 area code for its call without having to dial a “1”.

5. At the System-Wide Configuration> Time Server screen, set the Primary Time Server IP Address to a 

standard Time Server IP Address. This is not a required entry for the first call, but it is a good idea to set it 

at this point. 

Set the Secondary Time server IP Address to a standard Time Server IP Address.

Set the UTC Offset to -5 hours.

Clickon Confirm/OK.

6. At the VoIP Configuration> Gatekeeper/Border Element screen, set the Primary Border Element IP 

Address (i.e., 208.226.140.40 for Quintum’s test unit). Click on Confirm/OK.

7. At the VoIP Configuration> H323 Signaling Group screen, set the Primary Gatekeeper IP (i.e., 

208.226.140.40 for Quintum’s test unit)Clickon Confirm/OK. 

Allows the unit to get the information it needs to route your phone call to a specific IP address. 

8. At the System-Wide Configuration>  Circuit Configuration> Line Routing Configuration> Hunt LDN 

Directories> Hunt LDN Directory-pub 1 screen,enter a pattern.(i.e., 10 digit phone number that will be 

assigned to the phone on your end). Click on Confirm/OK. 

This provides the Gatekeeper with a phone number designation for your unit.

For use with a Cable Modem or DSL Modem and a Firewall only

9. At the Ethernet Configuration> Ethernet Interfaces> Ethernet Interface-1 screen and enter the External 

NAT IP (this is the IP that the service provider assigns to the firewall WAN port). Click Confirm/OK. 

This was tested with a Linksys™ firewall. Other types may work as well and should be configured simi-

larly. 

For use with a Cable Modem and No Firewall only

10. At the Ethernet Configuration> Ethernet Interfaces> Ethernet Interface-1 screen, check the Enable 

DHCP box. Click Confirm/OK. 

This provides a way for your service provider to assign an IP to your unit which can then be reached by the 

Gatekeeper on the public internet.

11. Submit all changes (through File>Sumit Changes).

12. Pick up the phone and hear dial tone. Dial 7324609000. The call should route to Quintum’s test unit and 

you should hear a recorded message.