Quintum Tenor AX Product Manual - page 67
P/N 480-0062-00-10
4-12
Chapter 4: Advanced Topic: View Call Detail Records
Call Disconnected Time: The date and time the call disconnected. The time will be the local time
configured on the Tenor AX unit. The entry will be in the following format: yyyymmddhhmmss
where yyyy (4 digits for year), mm (2 digits for month), dd (2 digits for day), hh (2 digits for hour),
mm (2 digits for minutes), ss (2 digits for seconds).
Disconnect Cause Code: The Q.931 cause value assigned if the call is not connected. Possible
common entries are listed below. This field will be blank if the call was connected.
Local IP Address: The IP address for the Tenor AX unit originating the CDR. The entry will be in
the following format: xxx.xxx.xxx.xxx.
Remote IP Address: IP address for the remote destination Tenor AX. This will be generated only if
the call is VoIP; if the call is circuit-based, this field will be blank.
Origination Trunk ID: Identifies the origination trunk ID of the line that initiated the call. This
field will be blank if no trunk ID is configured. The trunk ID is often configured with an account
code.
Call Type: The type of call. Valid entry: 1 = voice, 2 = fax, 3 = modem, 4 = data.
Call Number Type: The called numbering plan used for the call per Q.931. Possible common
entries are as follows: 1 = Public/E.164, 9 = Private.
Incoming Slot: The slot number to which a call enters. This entry is fixed at 2.
Cause Code
Definitions
16
Normal Call Clearing. The cause indicates that the call is being cleared
because one of the users has requested that the call be cleared.
17
User Busy. The called system acknowledges the connection request but
is unable to accept the call because all B channels are in use.
18
No User Responding. This code is used when a user does not respond to
a call establishment message with either an alerting or connect indication
within the prescribed period of time allocated (in Q.931 by the expiry of
either timer T303 or T310).
28
Invalid Number Format (Address Incomplete). The cause indicates
that the called user cannot be reached because the called party number is
not a valid format or is not complete.
31
Normal, Unspecified. This code is used to report a normal event only
when no other cause in the normal class applies.
34
No Circuit/Channel Available. The connection cannot be established
because no appropriate channel is available to take the call.
47
Resource Unavailable, Unspecified. This code is used to report a
resource unavailable event only when no other code applies.