Quooker PRO3-VAQ E Installation Manual - page 14
Disconnecting tank
• In case of service.
• The Q-shaped button on top of the tank is the on/off switch.
1
2
3
4
1 Switching off
Press the on/off switch at the top of
the tank to switch it off. Do not
unplug the tank from the socket yet.
2 Draining
Open the boiling-water tap or the
boiling-water handle of the Fusion tap
and leave the water running until it is
cold. Then close the tap again.
3 Isolating
Close the main shut-off valve or the
stop valve on the inlet combination
(small grey knob). Check that the
Quooker is depressurized by opening
the Nordic boiling-water tap or the
boiling-water handle of the Fusion tap
again. If it is depressurized, no water
should flow out of it.
4 Disconnecting
Unplug the tank from the socket and
the LED cable from the back of the
tank cover. Disconnect the hoses and
remove the tank.
F