QUORION LK-T21 User Manual - page 11
11
4.
Application for countries with fiscal law
4.1 Topology
4.2 Programming
The firmware, default configuration, character set or grapfic logo of the QPrint FM can be
programmed with QFlash, similarly to the QMP cash register series.
It is necessary to start the Boot-mode of QPrint:
- Switching On the QPrint holding key “F1” and “F3” depressed
(in the display appear “BOOTBLOCK V0.xx”).
- Connect the PC with a RS232-cabel to Port1 of the QPrint or
used a LAN-cabel to the Ethernet connector.
(the download is possible only about Port1 or LAN)
- Start the program “QFlash” and send the new data to the QPrint.
After it is necessary to make a Soft Reset of QPrint.
Switching On the QPrint with holding key “F2” and “F4” depressed.
Note: When the fiscal memory is active, it is necessary to make a recovery procedure (see special
description “Activation of Fiscal Memory” – regard the fiscal country)
Using QProg, the customer data can be programmed to the printer. Please check the
corresponding QFlash and QProg manuals for further information. Normally the printer will be pre-
configured when delivered, so there is no need to program it.
4.3 Activation of the Fiscal Memory
The FM-module can be activated either directly with an external keyboard and display or using a
special software at the PC.