Qvis G3-mini keyboard User Manual - Keyboard Parameter Setting
9
1 Keyboard setup
2 Dome setup
3 Protocol select
4 Exit menu
、
、
、
、
1 Set KB Parameter
2 About keyboard
、
、
Success!
Error!
1 Keyboard setup
2 Dome setup
3 Protocol select
4 Exit menu
、
、
、
、
1 Set KB ID
2 Set balldrate
3 Joy_calibrate
、
、
、
Input KB ID:
1-64
(
)
4
The Keyboard Menu Control
s
Press
the numerical key or move the
joystick up and
down to the option t h a t you need
and
then m o v e it right after entering the main
menu, which
can enter the relevant menu setting.
Picture 4 .1-1
*
*
【
】
Sa ving Setting
Press
Prev
,or move the joys tick le ftw ard s,
th en
retur n t o the previous menu.
Return to P revious menu
4. 1 Keyboard Parameter Setting
4. 1. 1 Set keyboard ID
1. Enter main
menu,LCD display ( See
pic ture 4.1.1-1 )
Picture 4.1 . 1-1
5.
2.
Press 【 1 】 then choose keyboard
setting. LCD will display the following
(See the picture 4.1.1-2)
3. Press 【 1 】 to choose keyboard
Specification. LCD will display the following (See
picture 4.1.1-3)
Pict ure 4.1.1-2
Pic ture 4.1.1-3
NO TICE
The fa ctory d efault ID of the keyboard is 1;
The ID Number must be 1 if the single keyboard
works; It can connect up to 4 keybo ard when
working on line, but make sure there is only a
keyboard ID set as 1,otherwise all the online
keyboards ca n not work normally.
4. Press 【 1 】 to choose keyboard ID setting.
LCD will display the following (See picture
4.1.1-4)
Picture 4.1.1-4
Picture 4.1.1-5
Picture 4.1.1-6
Keyboard Parameter Setting
, hold for 2 seconds. Go to the main
menu, the LCD will show the following in Picture 4.1-1.
Press
【SET】
Choose the relevant numerical keys according to the
menu hint. You can the enter the relevant function
settings. Press
【ENTER】to save settings; the LCD
will display "Success" after the set up is successfully
complete.
Press the relative numerical key (1-64); press
【ENTER】to confirm. The screen will display the
following (See picture 4.1.1-5). This means that the
operation has been completed successfully.
Press the
【PREV】button or move the joystick to
the left to go back through the menu stages
gradually.
The screen will show 'Error' if the inputted numerical
key is in excess of the ID scope (1-64). See picture
4.1.1-6.