R For Rabbit Honey Bunny Instruction Manual - page 3
Large Wheels
The large wheels are made from EVA materials. This
provides an optimum maneuverability and also brings ore
comfort to your child when using the stroller.
Step 2: Fitting the large wheels to the axle
a) Without releasing the
handlebar, move it to the
floor. The wheel axles now
face upwards. It is easy to
install the wheels this way.
b) Stand with wheel axles y
horizontally in front of you.
With the wheel facing
upwards and the large
wheel lock facing away from
you, push the large wheel
into the end of the holder.
Your will hear a ‘click’ for
each wheel. The large
wheels are now attached.
c) Press the button on large
wheel axle by one hand and
pull the wheel by another
hand to remove the large
wheel.
Note: Large wheel cannot be
removed if the brake is turned on.
Step 3: Fitting the underbag
a) The underbag hangs under
the carrycot or seat.
b) Remove the frame from the
chassis. Fit the underseat
bag to the chassis between
the axles of the wheels. The
touch fadteners are fixed to the large wheel axle, the
plastic pole fixed to the chassis by the screws.
(Underbag usually is assembled by the manufacturer.
Note: The underseat bag is made to carry maximum weight
of 4 kgs. Ensure that the tall touch fasteners are properly
attached before use.
Placing the swivel wheel in the
holder
a) You will hear a ‘click’ while
placing the swivel wheel to
the end of the wheel pipe.
Pull the wheel to check that it
is properly attached.
Swivel non – active
b) Push down the swivel lock.
Now the swivel is not
active, the stroller now
moves in straight line.
The Stroller Braking System
The parking brake is on rear axle. It
stops the large wheels from
turning. Always apply the parking
brakes while putting your child into
the stroller seat.
Step 4: Braking
a) Press the braking pole
downward.
Note: You will be able to feel when
the parking brakes are working
properly. Do not force the parking
brakes.
b) Releasing the parking brake:
Hold the handlebar firm and
lift the braking pole upwards
with another foot.
Fitting the Frame
c) The frame is attached to the
chassis. The carrycot or seat
are attached to the frame.
There are two frame bearers
on chassis. You will hear
‘click’ when you press the
frame on both sides of the
bearers.
Step 5: Fitting the frame on Chassis
a) Keeping the frame bearer
upright, press the frame on
the bearer till you hear a
click from both sides.
Warning; Check that the frame is
attached to the chassis. Try picking
up the frame, if it is easily picked, it
is not yet fixed properly.
Placing the frame in different positions
a) Place the frame on the
chassis. Squeeze together the
squeeze-fastener on center
axle. Tilt the frame by lifting
the top part. Put the frame in
one of the 3 positions
Note: Just the seat can be put in
3 frame positions. The carrycot
can only be used horizontally.