R2hobbies.com 1490mm AG4XXXX SPECTRE Soaring Thermal DLG Glider Installation Manual - page 5
1. Firstly, cutting off excessive covering along the corner of the wing with cutter.
2. Removing the covering on the ailerons servo mounts which is located in between the
second and third section of the main wing.
3. Joining the main wing: Take the 5mm carbon fiber rod out from the accessories bag
and joining the wing panels together with it and apply AB glue on the joining area to
secure each other. It is better to apply sticky tapes to ensure the panels are joining
together until the glue gets dried. When it is finished, remove the sticky tapes.
4. Take the pre-cut fibreglass clothes out from the accessories bag. Remove the cover-
ing base on the shape of the fibreglass clothes and glue the fibreglass clothes on the
joining area of the wing in order to strengthen panel connection.
Step 3: Main Wing Installation