R2hobbies.com 1490mm AG4XXXX SPECTRE Soaring Thermal DLG Glider Installation Manual - Step 4: Final Step
5. Installing main wing servos: Glue the servos to the servo carbines with AB glue and
pull the servo wires out thru the wing. (Like the pictures above.)
6. Installing discus handling rod: One of the corners of the wing has been strengthen
with carbon fiber cloth. You only need to insert the rod thru the wing and secure it with
AB glue. That’s it!
1. After main wing installation, put it on the fuse-
lage and secure it with screws. Using metal
screws at the front and nylon screws at the rear.
2. The CG is about 75-85mm behind from the
front edge of the wing. CG nearer to the front,
the stability is higher. In contrast, it would be
more nimble.
3. 7.4v 400mAh LiPo with 2A UBEC are recommended.
4. As the wing is thin, the wing shape might be changed from time to time. Therefore,
please check the angle before flying every time. If the wing is twisted, it can be fixed with
hair dryer.