RAB AL Installation Instructions

AL

TM

 AREA LIGHT INSTALLATION INSTRUCTIONS 

®

Page

Thank you for buying RAB lighting 

fixtures. Our aim is to design the 

best quality products to get the job 

done right.  We’d like to hear your 

comments. Call the Marketing 

Department at 888-RAB-1000, or 

email: marketing@rabweb.com

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE

.

RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper 

grounding is required for safety. This product must be installed in accordance with the applicable installation code by a 

person familiar with the construction and operation of the product and the hazards involved.

WARNING: 

Make certain power is OFF before installing or maintaining fixture.

MOUNTING wITH SLIPfITTER 

The slipfitter fits a 2 3/8” O.D. tenon.

Place the 

slipfitter over the tenon and secure with the 

(2) Set 

Screws on the side of the slipfitter.  

To adjust the angle of the fixture: 

a.  Remove (2) 

Cover Plate Screws and the 

Round Cover Plate. 

b.  Hold the top of fixture, loosen the 

Locking Bolt 

and swivel the fixture. 

c.  Tighten the 

Locking Bolt and re-attach the 

Round Cover Plate.

1.

2.

Locking 

Bolt

Set Screws

Round Cover 

Plate

Cover Plate 

Screws

fIXED ARM

For full cutoff, mount arm oriented as shown below. 

UP TILT fIXED ARM

For 6 degree up tilt, mount arm oriented as shown below. 

POLE DRILLING DETAIL

For mounting to a pole not drilled at RAB. 

Note:  These instructions do not cover all details or variations 

in equipment nor do they provide for every possible situation 

during installation, operation or maintenance.

RAB fixture designs are protected under 

U.S. and International Intellectual Property laws. 

Patent pending.