Rabbit RabbitCore RCM2200 User Manual - page 22
18
RabbitCore RCM2200
3.4 Sample Programs
Sample programs are provided in the Dynamic C
Samples
folder, which is shown below.
The various folders contain specific sample programs that illustrate the use of the corre-
sponding Dynamic C libraries. For example, the sample program
PONG.C
demonstrates
the output to the Dynamic C
STDIO
window.
Two folders contain sample programs that illustrate features unique to the RCM2200.
•
RCM2200
—Demonstrates the basic operation and the Ethernet functionality of the
RCM2200.
•
TCPIP
—Demonstrates more advanced TCP/IP programming for Z-World’s Ethernet-
enabled Rabbit-based boards.
Follow the instructions included with the sample program to connect the RCM2200 and
the other hardware identified in the instructions.
To run a sample program, open it with the
File
menu (if it is not still open), compile it
using the
Compile
menu, and then run it by selecting
Run
in the
Run
menu. The
RCM2200 must be in Program Mode (see Section 3.2, “Programming Cable”), and must
be connected to a PC using the programming cable.
More complete information on Dynamic C is provided in the Dynamic C User’s Manual.