Rabbit RabbitCore RCM2200 User Manual - page 41
User’s Manual
37
prototyping area and the holes at locations J7 and J8. The holes are spaced at 0.1" (2.5 mm),
and 40-pin headers or sockets may be installed at J7 and J8. The pinouts for locations J7 and
J8, which correspond to headers J1 and J2, are shown in Figure B-4.
Figure B-4. RCM2200 Prototyping Board Pinout
(Top View)
The small holes are also provided for surface-mounted components that may be installed
to the right of the prototyping area.
There is a 2.4" × 4" through-hole prototyping space available on the Prototyping Board.
VCC and GND traces run along the edge of the Prototyping Board for easy access. A
GND pad is also provided at the lower right for alligator clips or probes.
Figure B-5. VCC and GND Traces Along Edge of Prototyping Board
VCC
PC1
PC3
TPOUT+
PD3
PD5
/IOWR
PE1
TPIN+
PE5
PE7
A2
A0
GND
PC0
PC2
TPOUT-
LNK
PD4
/IORD
PE0
TPIN-
PE4
ACT
A3
A1
J7/J9
PA0
PA2
PA4
PA6
/RES
PB2
PB4
PB7
D6
D4
D2
D0
VCC
PA1
PA3
PA5
PA7
PB0
PB3
PB5
D7
D5
D3
D1
VBAT
GND
J8/J10
Note: These pinouts correspond to the
MASTER/SLAVE positions respectively.
GND pad
GND trace
VCC trace
CAUTION
Battery