Rabbit RabbitCore RCM2200 User Manual - page 28
24
RabbitCore RCM2200
Table A-1 lists the electrical, mechanical, and environmental specifications for the RCM2200.
Table A-1. RabbitCore RCM2200 Specifications
Parameter
RCM2200
RCM2210
RCM2250
Microprocessor
Rabbit 2000
®
at 22.1 MHz
Ethernet Port
10Base-T, RJ-45,
2 LEDs
10Base-T
(raw signals only)
10Base-T, RJ-45,
2 LEDs
Flash Memory
One 256K
Two 256K
SRAM
128K
512K
Backup Battery
Connection for user-supplied backup battery
(to support RTC and SRAM)
General-Purpose I/O
26 parallel I/0 lines grouped in five 8-bit ports (shared with serial ports):
• 16 configurable I/O
• 7 fixed inputs
• 3 fixed outputs
Additional Inputs
2 startup mode, reset
Additional Outputs
Status, reset
Memory, I/O Interface
4 address lines, 8 data lines, I/O read/write
Serial Ports
Four 5 V CMOS-compatible ports.
Two ports are configurable as clocked ports, one is a dedicated RS-232
programming port.
Serial Rate
Maximum burst rate = CLK/32
Maximum sustained rate = CLK/64
Slave Interface
A slave port allows the RCM2200 to be used as an intelligent peripheral
device slaved to a master processor, which may either be another Rabbit
2000 or any other type of processor
Real-Time Clock
Yes
Timers
Five 8-bit timers cascadable in pairs, one 10-bit timer with 2 match
registers that each have an interrupt
Watchdog/Supervisor
Yes
Power
4.75 V to 5.25 V DC, 134 mA
Operating Temperature
–40°C to +70°C
Humidity
5% to 95%, noncondensing
Connectors
Two IDC headers 2 × 13, 2 mm pitchs
Board Size
1.60" × 2.30" × 0.86"
(41 mm × 59 mm × 22 mm)