Rac RAC02 GPS User Manual - page 3
Preparing for Use
IMPORTANT: To get the best quality recordings when using this CarCam, always ensure
your windscreen is clean from dirt, smudges and fingerprints on both the inside and
outside of the windscreen. Such dirt and smudges can and will affect the quality of the
video recorded.
1. Insert the Memory Card into TF socket on the side of the CarCam. The exposed
contacts of the Memory Card should be placed into the slot facing the
LENS of the
CarCam (see Identification of Controls).
2. Place the CarCam onto the Mounting Bracket and slide sideways to lock into place.
3. Connect the 3.5mm plug from the GPS Module into the socket marked GPS on the
underside of the camera. Place the GPS module next to the windscreen just above the
dashboard for optimum reception. Once you have determined the most suitable location,
remove the white protective film from the gel pad and place the pad directly to the
windscreen. This gel pad is both removable and reusable. Please keep the white
protective film to maintain the adhesiveness of the gel pad when not in use.
If for any reason the gel sheet pad loses its adhesiveness, wipe clean with a damp lint
free cloth and allow to dry naturally before replacing the white protective film. Do not
immerse the GPS Module in water.
4. Insert the Cigar Lighter Power Adaptor cable into the USB Socket on the side of the
CarCam.
5. Place the Mounting Bracket suction pad on the inside of the windscreen and lock into
place by lifting up the lever.
6. Remove the protective film from the front of the lens and the LCD screen.
Important: Ensure the Mounting Bracket is located in such a way as to not block your
field of view while driving, or affect your ability to operate or control the car safely while
driving.
Never mount the CarCam in a position that could interfere with the operation
of any Air Bags in the event of a collision.